KAPKA self watering planter

  • 6.00
A hand holding the upper white pot, showing two white cotton ropes hanging from the bottom of the planter.
High-angle view of white, tan, and green self-watering planters sitting on a clean white tabletop.
A tan self-watering planter with a green plant, showing water being poured into the lower reservoir dish.
Three modern planters in white, tan, and green with different small green plants on a white table.
A green self-watering planter holding a large-leafed tropical plant against a white wall.
Invented bySimona - simiu3d

Simona - simiu3d

View store

Description

KAPKA - This innovative self-watering planter combines modern design with practical functionality. The planter uses a cotton rope system to adsorb water from a hidden reservoir. This water mechanism allows extended periods between waterings, perfect for busy individuals and travelers! Follow me on instagram for more https://www.instagram.com/simonauhrova3d/ I am excited to see your prints! Use ANY COTTON ROPE UP TO 6 mm diameter and place it according to the pictures provided. Dimensions: length 173 mm, width 120 mm, height 140 mm You can scale the model (remember to scale both parts in the same percentage), but more significant scaling might result in too tight of too loose turning mechanism, as the clearance is designed for 100 percent scale. To get the rough surface look on the upper part, apply fuzzy skin (slicer functionality) on the outside surfaces only. The parameters for fuzzy skin that I used were 0.4 mm thickness and 0.4 mm point distance. To avoid leaking, print the bottom part with at least 3-4 perimeters and 3 top and 3 bottom full layers.

$3.00 / month

KAPKA self watering planter

  • 6.00
Invented bySimona - simiu3d

Simona - simiu3d

View store

Description

KAPKA - This innovative self-watering planter combines modern design with practical functionality. The planter uses a cotton rope system to adsorb water from a hidden reservoir. This water mechanism allows extended periods between waterings, perfect for busy individuals and travelers! Follow me on instagram for more https://www.instagram.com/simonauhrova3d/ I am excited to see your prints! Use ANY COTTON ROPE UP TO 6 mm diameter and place it according to the pictures provided. Dimensions: length 173 mm, width 120 mm, height 140 mm You can scale the model (remember to scale both parts in the same percentage), but more significant scaling might result in too tight of too loose turning mechanism, as the clearance is designed for 100 percent scale. To get the rough surface look on the upper part, apply fuzzy skin (slicer functionality) on the outside surfaces only. The parameters for fuzzy skin that I used were 0.4 mm thickness and 0.4 mm point distance. To avoid leaking, print the bottom part with at least 3-4 perimeters and 3 top and 3 bottom full layers.

$3.00 / month